Maytag Dishwasher F8-E1 error code

F8-E1 means the dishwasher did not detect enough water entering the tub. It is a slow-fill or no-fill fault — the control waited for water that never arrived in time.

Also shown as: F8-E1, F8 E1, F8E1

Last updated: October 6, 2026

Quick answer: Maytag dishwasher error code F8-E1: water fill fault. The most common cause is water supply valve under the sink turned off or partially closed. Try this first — confirm the water supply is fully on. If that does not clear it, straighten the inlet hose.

What causes the F8-E1 error?

  • Water supply valve under the sink turned off or partially closed
  • Kinked or pinched inlet hose behind the dishwasher
  • Clogged inlet valve filter screen
  • Low household water pressure (below about 20 PSI)
  • Failed water inlet valve
  • Failed flow meter or level sensor misreading the fill

How to fix Maytag F8-E1 — step by step

Work through these in order, from simplest and safest first. Stop as soon as the code clears.

  1. Confirm the water supply is fully on
    Check the hot water shutoff valve under the sink that feeds the dishwasher. Turn it fully counterclockwise. This is the most common cause after plumbing work.
  2. Straighten the inlet hose
    If you can access behind the unit, check that the inlet hose is not kinked or crushed. A pinched hose starves the fill valve.
    Safety warning: Do not pull a built-in dishwasher out alone. Get help or call a technician.
  3. Clean the inlet valve screen
    With the water and power off, a technician can disconnect the inlet hose at the valve and rinse the small filter screen. Sediment from plumbing work clogs it often.
    Safety warning: Turn off the water supply before disconnecting any hose.
  4. Run the hot tap first
    Run the kitchen hot tap for a minute before starting the dishwasher. This clears cold standing water and confirms you actually have water pressure at the sink.
Related guide: Dishwasher troubleshooting — fix common problems, with links to every dishwasher error code we cover.

When to call a technician

Stop and call a qualified technician if any of these apply:
  • Water is on and the hose is straight but the tub stays dry
  • The inlet valve needs testing or replacement
  • Your home has chronically low water pressure
  • The dishwasher is under warranty

Frequently asked questions

The dishwasher hums but no water comes in. Is that F8-E1?

Yes. The fill valve is energized (the hum) but water is not reaching the tub — a closed valve, kinked hose, or clogged screen.

Could low water pressure cause this?

Yes. Below about 20 PSI the dishwasher cannot fill in the time the control allows, and it flags F8-E1.

Is F8-E1 the same as F8-E4?

No. F8-E1 is too little water (fill fault). F8-E4 is too much water (overfill/float).

Sources

Every meaning and fix above was checked against official manufacturer documentation:

FixCode provides general troubleshooting information only — not professional repair advice. If you are unsure about any step, stop and call a qualified technician. Repairs done incorrectly can be dangerous and may void your warranty.

Related error codes

Bosch E15 Bosch E24 Bosch E25 Bosch E22 Bosch E23 Bosch E09 Bosch E12 Bosch E14

All Dishwasher error codes across brands · All Maytag codes →