Maytag Dishwasher F2-E2 error code

F2-E2 means the user interface (the keypad and display on the door) cannot communicate with the main control board. The control is not reliably hearing your button presses.

Also shown as: F2-E2, F2 E2, F2E2

Last updated: October 6, 2026

Quick answer: Maytag dishwasher error code F2-E2: control panel communication fault. The most common cause is loose or damaged wire harness between the door panel and the main board. Try this first — press Cancel, then power reset. If that does not clear it, check for stuck keys.

What causes the F2-E2 error?

  • Loose or damaged wire harness between the door panel and the main board
  • Failing user interface (keypad/display) electronics
  • Failing main electronic control board
  • Moisture behind the console from steam or splashes
  • A stuck key confusing the communication check
  • Voltage spike damaging one of the boards

How to fix Maytag F2-E2 — step by step

Work through these in order, from simplest and safest first. Stop as soon as the code clears.

  1. Press Cancel, then power reset
    Press Cancel/Drain once, then turn off the breaker for one minute. Restore power and try Start. This re-syncs the panel and the main board.
  2. Check for stuck keys
    Press each button once and confirm it moves and releases normally. If the console recently got wet at the top of the door, let it dry fully with power off.
    Safety warning: Do not spray cleaner directly on the console.
  3. Confirm the door latches firmly
    Close the door firmly and confirm the latch catches every time. A door that does not latch cleanly can mimic control communication faults.
  4. Note when the code appears
    If the code appears the moment power is restored, suspect the keypad or console wiring. If it appears mid-cycle, suspect an intermittent harness connection shaken loose by vibration.
    Safety warning: Internal harness checks need a technician.
Related guide: Dishwasher troubleshooting — fix common problems, with links to every dishwasher error code we cover.

When to call a technician

Stop and call a qualified technician if any of these apply:
  • The code returns right after the power reset
  • Buttons are unresponsive or the dishwasher beeps randomly
  • The console got wet and drying did not help
  • The dishwasher is under warranty

Frequently asked questions

The buttons do nothing but the display lights up. Is that F2-E2?

Yes, that is typical. The display can light up while the keypad circuit fails to send presses to the main board.

Can I still run the dishwasher?

No. Without reliable panel communication, the dishwasher cannot accept or confirm cycles safely.

Do I need a new control panel or a new board?

It could be either, or just the harness. A technician should diagnose before you buy parts — the main board is the more expensive guess.

Sources

Every meaning and fix above was checked against official manufacturer documentation:

FixCode provides general troubleshooting information only — not professional repair advice. If you are unsure about any step, stop and call a qualified technician. Repairs done incorrectly can be dangerous and may void your warranty.

Related error codes

Bosch E15 Bosch E24 Bosch E25 Bosch E22 Bosch E23 Bosch E09 Bosch E12 Bosch E14

All Dishwasher error codes across brands · All Maytag codes →