Kenmore Dishwasher AE error code

The dishwasher found water sitting in its base pan, which trips a flood switch. Some models instead sense the circulation pump spinning too fast because the water level is low. Either way, the control believes there's a leak and stops the cycle to keep your kitchen from flooding. This one shows up on Kenmore 722 dishwashers as AE or E1.

Also shown as: E1, AE/E1

Last updated: October 8, 2026

Quick answer: Kenmore dishwasher error code AE: water leak detected in the dishwasher base. The most common cause is water leaking into the base from the fill line, inlet guide, drain pump, drain hose, door seals, or sump. Try this first: shut off power and water, then look for the leak.

What causes the AE error?

  • Water leaking into the base from the fill line, inlet guide, drain pump, drain hose, door seals, or sump.
  • A flood switch that tripped with a dry base, meaning a false trip.
  • A badly installed drain hose letting water siphon out, which drops the water level.
  • A low water level from a supply problem.

How to fix Kenmore AE: step by step

Work through these in order, from simplest and safest first. Stop as soon as the code clears.

  1. Shut off power and water, then look for the leak
    Unplug the dishwasher and close the water supply valve. Check the cabinet base for standing water, then trace the source: fill line, door seals, drain hose, pump, or sump. Fix the leak and dry the base out completely.
    Safety warning: Standing water and household current don't mix. Confirm the breaker is off before you reach into the base.
  2. Check the flood switch
    If the base is dry but the code won't clear, disconnect the flood switch wires and test the switch with a meter. It should read infinite resistance when dry. A near-zero reading means it tripped falsely and should be replaced.
  3. Verify the drain hose installation
    The drain hose needs to loop up high before it connects to the sink or disposal. A hose routed too low lets water siphon out, and that alone can set this code with no actual leak.
Related guide: Dishwasher troubleshooting: fix common problems, with links to every dishwasher error code we cover.

When to call a technician

Stop and call a qualified technician if any of these apply:
  • You can't find where the leak is coming from.
  • The code returns with a dry base and a good flood switch.

Frequently asked questions

What is the difference between AE/E1 and FE?

On Kenmore 722 dishwashers, AE or E1 means water was found in the base pan, which points to a leak. FE means a water overflow was detected up in the tub.

Sources

Every meaning and fix above was checked against official manufacturer documentation:

FixCode provides general troubleshooting information only. It is not professional repair advice. If you are unsure about any step, stop and call a qualified technician. Repairs done incorrectly can be dangerous and may void your warranty.

Related error codes

All Dishwasher error codes across brands · All Kenmore codes →