Frigidaire Dishwasher i30 error code
The leak sensor found water in the pan under the tub. Something is leaking or overflowing, so the dishwasher killed the cycle to protect your floor and cabinets.
Last updated: October 8, 2026
What causes the i30 error?
- A loose inlet valve connection
- The unit standing crooked so water pools and spills
- Over-sudsing pushing water out
- A leaking hose or tub seal
How to fix Frigidaire i30: step by step
Work through these in order, from simplest and safest first. Stop as soon as the code clears.
- Check the inlet valve connections
Inspect the valve connections for drips or looseness and tighten what is loose. Keep a towel handy, even a slow drip keeps the pan wet.Safety warning: Turn off the water supply before touching inlet connections. - Level the dishwasher
Level the unit properly. A tilted dishwasher pools water where it should not and spills into the pan. - Reset and retry
Press cancel, or cut power at the breaker for five minutes, then start a cycle. If the pan is dry and the code stays away, it may have been a one-off splash.
When to call a technician
- Water returns to the pan on the next cycle
- You can see a drip you cannot reach
- The code persists with no visible leak
Frequently asked questions
Can I keep using the dishwasher with i30?
No. i30 is a leak warning, and running the machine risks floor and cabinet damage. Find the water source first, then run it.
Sources
Every meaning and fix above was checked against official manufacturer documentation:
FixCode provides general troubleshooting information only. It is not professional repair advice. If you are unsure about any step, stop and call a qualified technician. Repairs done incorrectly can be dangerous and may void your warranty.
Related error codes
All Dishwasher error codes across brands · All Frigidaire codes →