Frigidaire Dishwasher i20 error code
The dishwasher cannot pump water out. Filters are clogged or the drain line is restricted. This is one of the most common dishwasher faults, and it is usually a blockage you can clear yourself.
Also shown as: i40, iF0
Last updated: October 8, 2026
What causes the i20 error?
- Food-clogged filters or sump
- A pinched or blocked drain hose
- Disposer knockout plug left in on a new install
- Debris in the drain path
How to fix Frigidaire i20: step by step
Work through these in order, from simplest and safest first. Stop as soon as the code clears.
- Clean the filters and sump
Pull the lower rack, lift out both filters, and rinse them under the tap. Then scoop food debris from the sump beneath. - Check the drain hose
Confirm the hose is not pinched or blocked. If it runs to a garbage disposer, make sure the knockout plug was removed at install, a missed plug seals the drain shut. - Reset and retry
Press cancel, or cut power at the breaker for five minutes, then run again. With the blockage gone, the cycle should finish.
When to call a technician
- Water will not drain after cleaning everything
- The drain pump runs but moves no water
Frequently asked questions
What's the difference between i20, i40, and iF0?
Same fault, same fix. Frigidaire groups i20, i40, and iF0 together in the manual: restricted drainage. Clean the filters and check the drain hose for all three.
Sources
Every meaning and fix above was checked against official manufacturer documentation:
FixCode provides general troubleshooting information only. It is not professional repair advice. If you are unsure about any step, stop and call a qualified technician. Repairs done incorrectly can be dangerous and may void your warranty.
Related error codes
All Dishwasher error codes across brands · All Frigidaire codes →