Frigidaire Dishwasher i10 error code

The dishwasher did not get enough water in time. The fill ran too slow or never happened, and the spray arms cannot clean without water in the tub.

Last updated: October 8, 2026

Quick answer: Frigidaire dishwasher error code i10: too little water reaching the tub. The most common cause is a pinched supply line. Try this first: check the water supply. If that does not clear it, reset and retry. If the code persists, call a qualified technician.

What causes the i10 error?

  • A pinched supply line
  • The shutoff valve not fully open
  • Low household water pressure
  • A failed inlet valve

How to fix Frigidaire i10: step by step

Work through these in order, from simplest and safest first. Stop as soon as the code clears.

  1. Check the water supply
    Look under the sink for a kinked or pinched line, and open the shutoff valve all the way. A half-open tap starves the dishwasher.
  2. Reset and retry
    Hit cancel, or kill power at the breaker for five minutes, then start again. A one-off fill glitch clears this way.
Related guide: Dishwasher troubleshooting: fix common problems, with links to every dishwasher error code we cover.

When to call a technician

Stop and call a qualified technician if any of these apply:
  • The tub still will not fill with good supply
  • You suspect the inlet valve is bad

Frequently asked questions

How do I know if it's a supply problem or a bad valve?

With the shutoff fully open and the line unkinked, yet little or no water entering, the inlet valve is the likely failure. Valve replacement is a technician job.

Sources

Every meaning and fix above was checked against official manufacturer documentation:

FixCode provides general troubleshooting information only. It is not professional repair advice. If you are unsure about any step, stop and call a qualified technician. Repairs done incorrectly can be dangerous and may void your warranty.

Related error codes

All Dishwasher error codes across brands · All Frigidaire codes →