Bosch Dishwasher E06 error code

E06 means there is a door sensor circuit fault. The dishwasher cannot confirm the door is properly closed and latched, so it will not start the cycle.

Also shown as: E06, E:06, E 06

Last updated: October 6, 2026

Quick answer: Bosch dishwasher error code E06: door sensor fault. The most common cause is door not fully closed or latched. Try this first — close the door firmly. If that does not clear it, reset power at the breaker for 30 seconds.

What causes the E06 error?

  • Door not fully closed or latched
  • Obstruction in the door latch (rack, utensil)
  • Failed door latch sensor or reed switch
  • Misaligned door
  • Damaged wiring to the door sensor
  • On some models, a faulty aqua (turbidity) sensor reading as E06

How to fix Bosch E06 — step by step

Work through these in order, from simplest and safest first. Stop as soon as the code clears.

  1. Close the door firmly
    Open the door, make sure no rack or utensil sticks out, then push it shut firmly until the latch clicks. Press Start again.
  2. Reset power at the breaker for 30 seconds
    Turn off the breaker for 30 seconds, then restore power. This is Bosch's official first step and clears sensor glitches.
  3. Check the latch for debris
    Look at the latch area on the tub frame for food particles or a bent strike plate. Clean out anything blocking full closure.
    Safety warning: Turn off the breaker before inspecting the latch closely.
  4. Wipe the door seal
    A dirty or sticky door gasket can hold the door a few millimeters open. Wipe the gasket with a damp cloth and close the door again.
Related guide: Dishwasher troubleshooting — fix common problems, with links to every dishwasher error code we cover.

When to call a technician

Stop and call a qualified technician if any of these apply:
  • E06 returns after the reset with a firmly latched door
  • The latch is visibly broken or the door will not stay shut
  • The sensor or latch switch needs replacement
  • The dishwasher is under warranty

Frequently asked questions

The door looks closed but E06 shows. Why?

The sensor needs full latch engagement. A slightly misaligned door or a weak latch can leave the sensor open even when the door looks shut.

Can I run the dishwasher with E06 showing?

No. The dishwasher will not start until the door sensor confirms a proper close — this is a safety interlock.

What if the door closes fine but the code stays?

Then the sensor, its wiring, or the latch switch has failed and needs a technician to test and replace.

Sources

Every meaning and fix above was checked against official manufacturer documentation:

FixCode provides general troubleshooting information only — not professional repair advice. If you are unsure about any step, stop and call a qualified technician. Repairs done incorrectly can be dangerous and may void your warranty.

Related error codes

Bosch E15 Bosch E24 Bosch E25 Bosch E22 Bosch E23 Bosch E09 Bosch E12 Bosch E14

All Dishwasher error codes across brands · All Bosch codes →