Kenmore Dryer F:31 error code

The control board measured the L2 leg of the dryer's 240-volt supply and found it under 30 volts. In plain English, the dryer is only getting about half the power it needs. It can't heat or tumble properly on half power, so it stops and shows F:31.

Also shown as: F31, F-31

Last updated: October 8, 2026

Quick answer: Kenmore dryer error code F:31: dryer is only getting half its 240 volts. The most common cause is a house breaker that tripped, or half-tripped on one leg. Try this first: reset both breaker switches. If that does not clear it, inspect the power cord and terminal block.

What causes the F:31 error?

  • A house breaker that tripped, or half-tripped on one leg.
  • A wire on the dryer's terminal block that's loose or corroded.
  • A damaged power cord.
  • A faulty 240V outlet or a problem in the house wiring.

How to fix Kenmore F:31: step by step

Work through these in order, from simplest and safest first. Stop as soon as the code clears.

  1. Reset both breaker switches
    Find the dryer's double breaker in your house panel. Flip it all the way off, then back on. A 240V breaker can look fine while one leg is still tripped, so push it fully off first.
  2. Inspect the power cord and terminal block
    Unplug the dryer and take off the small cover where the cord connects. Snug up any loose wire connections. If the cord looks damaged or discolored, replace it before running the dryer again.
    Safety warning: The terminal block carries 240 volts. Always unplug the dryer before opening that cover.
  3. Have an electrician check the supply
    If the breaker, cord, and connections all look right, call an electrician to measure the outlet voltage. The dryer needs roughly 208 to 240 volts across both legs.
    Safety warning: House wiring repairs belong to a licensed electrician.

When to call a technician

Stop and call a qualified technician if any of these apply:
  • The outlet still reads low after you reset the breaker.
  • Wires at the terminal block look burned or melted.

Frequently asked questions

Can I run the dryer on 120V temporarily?

No, and don't try. An electric Kenmore dryer needs the full 240 volts to heat and tumble safely. Running it on partial power can damage the motor and the electronics.

Sources

Every meaning and fix above was checked against official manufacturer documentation:

FixCode provides general troubleshooting information only. It is not professional repair advice. If you are unsure about any step, stop and call a qualified technician. Repairs done incorrectly can be dangerous and may void your warranty.

Related error codes

All Dryer error codes across brands · All Kenmore codes →