Kenmore Dryer AF error code

The dryer is telling you exhaust air can't get out. That's hot air with nowhere to go, which usually means the lint screen, the vent hose, or the vent cap outside is blocked. When airflow drops, clothes take forever to dry and the machine runs hotter than it should, so the dryer stops and puts AF on the screen. Some Kenmore Oasis models show F-30 for the exact same problem.

Also shown as: F-30, F30

Last updated: October 8, 2026

Quick answer: Kenmore dryer error code AF: exhaust airflow blocked: check lint screen and vent. The most common cause is a lint screen plugged with lint, or coated with an invisible layer of fabric-softener residue. Try this first: clean the lint screen.

What causes the AF error?

  • A lint screen plugged with lint, or coated with an invisible layer of fabric-softener residue.
  • A vent duct that's crushed, kinked, or just run too long and twisty.
  • The vent flap outside is stuck shut or blocked by lint, leaves, or snow.
  • The dryer sits too close to the wall and the hose gets pinched behind it.

How to fix Kenmore AF: step by step

Work through these in order, from simplest and safest first. Stop as soon as the code clears.

  1. Clean the lint screen
    Pull the screen and scrape off every bit of lint. If you use dryer sheets, scrub the mesh with warm water and a soft brush. Softener residue can seal the mesh shut even when the screen looks perfectly clean.
  2. Clear the exhaust vent duct
    Unplug the dryer, pull it away from the wall, and disconnect the vent hose. Vacuum lint out of the hose, the port on the back of the dryer, and the wall vent. When you hook it back up, keep the run as short and straight as you can.
    Safety warning: Unplug the dryer before working around the vent or terminal block. An electric dryer runs on 240 volts.
  3. Check the outside vent hood
    Walk outside and look at the vent cap. The flap should swing open freely. A flap stuck shut or jammed with lint is enough to set this code all by itself.

When to call a technician

Stop and call a qualified technician if any of these apply:
  • AF comes back after you've cleaned the whole vent run.
  • You smell something burning or see scorch marks around the vent.
  • The dryer runs hot or shuts itself off even on a no-heat cycle.

Frequently asked questions

Is the AF code dangerous?

It can become dangerous if you ignore it. Hot air with nowhere to go strains the heating element, and lint choked into a hot duct is a genuine fire risk. Get the vent cleared before you run the dryer again.

Does AF mean the same thing as F-30?

Yes. On Kenmore Oasis dryers, AF and F-30 are the same exhaust-airflow warning under two different labels.

Sources

Every meaning and fix above was checked against official manufacturer documentation:

FixCode provides general troubleshooting information only. It is not professional repair advice. If you are unsure about any step, stop and call a qualified technician. Repairs done incorrectly can be dangerous and may void your warranty.

Related error codes

All Dryer error codes across brands · All Kenmore codes →