Maytag Washing Machine F9E1 error code
The washer tried to drain and the water wouldn't leave fast enough. The control watches the drain timer, and when the tub is still holding water past its limit, it flags a long drain and halts the cycle. It would rather stop wet than try to spin a tub full of standing water.
Also shown as: Long Drain
Last updated: October 8, 2026
What causes the F9E1 error?
- The drain hose is kinked, pinched flat against the wall, or pushed so far into the standpipe that water can't flow freely.
- The drain pump filter is clogged with lint, socks, coins, or gunk caught in the pump.
- The hose is sealed airtight into the drain pipe with no air gap, so air can't vent and water can't drain out.
- The drain pump itself is wearing out and can no longer push water out with enough force.
How to fix Maytag F9E1: step by step
Work through these in order, from simplest and safest first. Stop as soon as the code clears.
- Inspect the drain hose
Work the hose loose from behind the washer and check its whole length for kinks or crushing. It should go into the standpipe no more than about 4.5 inches, and it must not be sealed airtight into the pipe. Air needs to vent around it for the drain to work. - Clean the drain pump filter
Unplug the washer first, then open the pump filter access panel, usually at the lower front. Put a towel and a shallow pan underneath, unscrew the filter, and pull out lint, coins, hair, and anything else trapped in there. Screw it back in firmly.Safety warning: Unplug the washer first and expect residual water to spill when you open the filter. - Run a drain-and-spin test
Plug the washer back in and run a Drain and Spin cycle with the drum empty. Watch the hose end or listen for the pump. Strong, steady flow means the path is clear again.
When to call a technician
- The code comes back with a clear hose and a clean filter.
- The pump grinds, rattles, or doesn't run at all.
- Water is still standing in the tub after the test cycle.
Frequently asked questions
How far should the drain hose go into the standpipe?
About 4.5 inches, 114 millimeters, or less, with an air gap around the hose. Push it in deeper and you can get siphoning problems that keep tripping drain faults.
Sources
Every meaning and fix above was checked against official manufacturer documentation:
FixCode provides general troubleshooting information only. It is not professional repair advice. If you are unsure about any step, stop and call a qualified technician. Repairs done incorrectly can be dangerous and may void your warranty.
Related error codes
All Washing Machine error codes across brands · All Maytag codes →