Kenmore Oven F3/E0 error code

The oven's temperature sensor circuit is open, which means the control isn't getting any signal from the sensor at all. With no temperature feedback, the control can't regulate heat, so it locks out the oven and shows F3/E0. This one is common on Kenmore 665 ranges.

Also shown as: F3 E0, F3-E0

Last updated: October 8, 2026

Quick answer: Kenmore oven error code F3/E0: oven temperature sensor circuit is open. The most common cause is the sensor probe itself burned out. Try this first: reset the range. If that does not clear it, reseat the sensor connection. If the code persists, call a qualified technician.

What causes the F3/E0 error?

  • The sensor probe itself burned out.
  • A loose or corroded wire connection at the sensor.
  • A damaged wire harness running behind the oven.
  • A failing electronic oven control board.

How to fix Kenmore F3/E0: step by step

Work through these in order, from simplest and safest first. Stop as soon as the code clears.

  1. Reset the range
    Kill power at the breaker for a couple of minutes, then turn it back on and try the oven. Sometimes this is just a one-time electronic hiccup.
  2. Reseat the sensor connection
    With the power off, find the slim metal probe poking out of the upper rear wall inside the oven. Pull it forward a little and push its wire connector back on firmly. While you're there, check the wiring where it passes through the back panel.
    Safety warning: Always cut power at the breaker before touching any wiring. The range runs on 240 volts.
  3. Test or replace the sensor
    Check the sensor's resistance with a meter. It should read about 1,080 ohms at room temperature (70 degrees F). If it's way off or reads open, the sensor needs replacing. If the sensor tests fine, the oven control is your remaining suspect.
    Safety warning: If you smell gas at any point on a gas range, get out of the house and call your gas company. Don't keep troubleshooting.

When to call a technician

Stop and call a qualified technician if any of these apply:
  • The sensor resistance checks out but the code stays.
  • You're not comfortable pulling panels or working with a meter.

Frequently asked questions

Can I still use the cooktop with F3/E0?

Usually, yes. This code only locks out the oven. The surface burners work independently of the oven temperature sensor.

What is the difference between F3/E0 and F3/E1?

F3/E0 means the sensor circuit is open, so no signal at all. F3/E1 means it's shorted, so the signal is stuck. Same sensor failing two different ways.

Sources

Every meaning and fix above was checked against official manufacturer documentation:

FixCode provides general troubleshooting information only. It is not professional repair advice. If you are unsure about any step, stop and call a qualified technician. Repairs done incorrectly can be dangerous and may void your warranty.

Related error codes

All Oven error codes across brands · All Kenmore codes →