Frigidaire Oven F10 error code

The control saw the oven temperature run past the programmed setting and keep climbing. That is thermal runaway, a genuine safety fault, so the oven cut the heat. Do not brush this one off.

Last updated: October 8, 2026

Quick answer: Frigidaire oven error code F10: oven overheating, thermal runaway. The most common cause is a failed oven temp sensor (the probe). Try this first: cut power if the oven is overheating. If that does not clear it, reset the range.

What causes the F10 error?

  • A failed oven temp sensor (the probe)
  • A shorted relay on the control board
  • A control board fault

How to fix Frigidaire F10: step by step

Work through these in order, from simplest and safest first. Stop as soon as the code clears.

  1. Cut power if the oven is overheating
    If it is visibly overheating, switch it off and kill power at the breaker immediately. Let it cool fully before touching anything else.
    Safety warning: An overheating oven is a fire risk. Do not leave it unattended, and do not use it until it is serviced.
  2. Reset the range
    With the oven cool, cut power for up to 30 seconds, restore it, and see if the code returns. A repeat means the fault is real.

When to call a technician

Stop and call a qualified technician if any of these apply:
  • It overheats again after the reset
  • The code appears during normal baking
  • You smell burning, get service before using the oven again

Frequently asked questions

Is F10 dangerous?

It can be. The oven may not be controlling its own temperature. Cut the power and have it serviced instead of cooking through it.

Sources

Every meaning and fix above was checked against official manufacturer documentation:

FixCode provides general troubleshooting information only. It is not professional repair advice. If you are unsure about any step, stop and call a qualified technician. Repairs done incorrectly can be dangerous and may void your warranty.

Related error codes

All Oven error codes across brands · All Frigidaire codes →