Frigidaire Washing Machine E44 error code

The lid-closed sensing circuit is not confirming that the lid is shut. The washer will not run until the control gets that signal.

Also shown as: E44

Last updated: October 6, 2026

Quick answer: Frigidaire washing machine error code E44: lid-closed sensor failure. The most common cause is faulty lid lock assembly. Try this first — reseat the lid firmly. If that does not clear it, inspect the strike and alignment. If the code persists, call a qualified technician.

What causes the E44 error?

  • Faulty lid lock assembly
  • Lid misaligned so the closed sensor never triggers
  • Broken or worn lid strike
  • Loose wiring harness to the lock assembly
  • Control board not reading the sensor signal

How to fix Frigidaire E44 — step by step

Work through these in order, from simplest and safest first. Stop as soon as the code clears.

  1. Reseat the lid firmly
    Open the lid, remove anything blocking the rim, then close it firmly until the latch clicks. A lid that looks closed but is not fully latched will not satisfy the sensor.
  2. Inspect the strike and alignment
    Check the strike tab on the lid and the lock opening on the washer for cracks, wear, or misalignment. Gently wiggle the lid when closed: excessive play means the strike is not engaging the sensor.
  3. Power-reset the washer
    Unplug the washer for 5 minutes, then restore power and try a cycle. This clears a false sensing fault from a glitch.
  4. Call a technician for lock or board testing
    If the hardware looks fine and E44 returns, the lid lock assembly or the control board needs professional testing. A technician can check the sensor circuit and replace the failed part.

When to call a technician

Stop and call a qualified technician if any of these apply:
  • The lid lock assembly is visibly damaged
  • E44 persists with a firmly closed, well-aligned lid
  • The sensor circuit needs electrical testing
  • The main control board is the culprit after lock hardware tests good

Frequently asked questions

E41 vs E44: what is the difference?

They are close cousins. E41 means the main lid switch reads open. E44 means the separate lid-closed sensing circuit specifically is not confirming closure. Both stop the washer from running.

I read that E44 means a bad control board. Is that true?

Some older service manuals list E44 as a control board fault. Current diagnostic guides treat it as a lid-closed sensing failure first, with the board as the fallback if the lock hardware tests good.

Can I just disable the lid lock?

Not safely. The lid lock is a safety interlock. A failed lock assembly needs proper replacement.

Sources

Every meaning and fix above was checked against official manufacturer documentation:

FixCode provides general troubleshooting information only — not professional repair advice. If you are unsure about any step, stop and call a qualified technician. Repairs done incorrectly can be dangerous and may void your warranty.

Related error codes

Samsung 4E Samsung 5E Samsung UE Samsung LE Samsung dE Samsung 3E Samsung Sud LG OE

All Washing Machine error codes across brands · All Frigidaire codes →