Lennox Furnace LED off error code

The red LED on the ignition control is completely dark. Either the board has no power at all, or the board itself has died.

Also shown as: no LED, LED not lit, dark LED, no light on control board

Last updated: October 8, 2026

Quick answer: Lennox furnace error code LED off: no power to the board, or board failure. The most common cause is the breaker has tripped, or the furnace service switch is off. Try this first: check power. If that does not clear it, reseat the blower door.

What causes the LED off error?

  • The breaker has tripped, or the furnace service switch is off
  • The blower compartment door is not fully closed, so the door switch is open
  • The low-voltage fuse is blown, or the transformer has failed
  • The ignition control board has failed

How to fix Lennox LED off: step by step

Work through these in order, from simplest and safest first. Stop as soon as the code clears.

  1. Check power
    Make sure the furnace breaker is on and the service switch near the furnace is in the ON position.
  2. Reseat the blower door
    Open and firmly close the blower compartment door. Its safety switch cuts power whenever the door is ajar.
  3. Call a technician
    If power is good and the LED stays dark, the transformer, the fuse, or the board needs professional testing.
    Safety warning: Do not open the electrical compartment yourself. Line voltage inside can cause severe shock. Leave panel work to a qualified technician.

When to call a technician

Stop and call a qualified technician if any of these apply:
  • The breaker and switch are on, but the LED stays dark
  • The breaker trips again after you reset it

Frequently asked questions

Is a dark LED the same as a fault code?

No. A dark LED means the board is not running at all, so it cannot display codes. It is a power problem, not a specific fault.

Could the thermostat cause this?

A dead thermostat cannot cut power to the board's LED. Check the breaker and the door switch first.

Sources

Every meaning and fix above was checked against official manufacturer documentation:

FixCode provides general troubleshooting information only. It is not professional repair advice. If you are unsure about any step, stop and call a qualified technician. Repairs done incorrectly can be dangerous and may void your warranty.

Related error codes

All Furnace error codes across brands · All Lennox codes →